>>> GA10C SWEEP/SIGNAL GENERATOR <<<

  Shown in Figures 1 through 4 is a Sweep/Signal Generator Assembly using the LOA1K and the GAD VCO DRIVER to produce  -3 to 6 dBm output at frequencies from 275  to 1050 MHz on the front panel SMA connector.  See Figures 8 through 11 for frequency and power plots.

  For signal and swept frequency applications, the  front panel dial is used to set the center frequency (CF).  To generate a swept frequency (Delta F), connection of a triangle waveform from a function generator to the GA10C back panel BNC connector is required.  Click on this hyperlink, , for additional Delta F information.

  Figure 3 shows two holes (SW and SB) in the chassis bottom that allow access to two 2-pin headers.  Installation or removal of a short is required on each header to change frequency bands and produce the Stand-By (SB) mode.  The header functions are identified in Figure 6.

  The GA10C is supplied with a 36 inch length  power cable permanently attached for connection to the 11K18 DC power supply.  See Figure 7 for details.  Figure 2 shows the location on the chassis back panel of the DC power connections.  +18 VDC (Green) and -18 VDC (Yellow) connect to the chassis back panel feed-thru terminals, and common ground (black) is connected to a solder lug located on the lower center of the chassis back panel.

Figure 1, Front View

===

Figure 2, Back View

===

Figure 3, Bottom View

===

Figure 4, Internal Top View

===

Figure 5, Internal Side View

===

Figure 6, GA10C & 11K18 Power Supply

===

Figure 7, Header Identification

===

Figure 8, Band A Output Frequency

===

Figure 9, Band A Output Power

===

Figure 10, Band B Output Frequency

===

Figure 11, Band B Output Power

===

FOR ONLINE ORDERING, A U.S. SHIP TO ADDRESS IS REQUIRED.  INTERNATIONAL ORDERING INFORMATION IS AVAILABLE BY CLICKING ON THIS HYPERLINK, INTERNATIONAL

===

AZD HOME PAGE